TuneBoy For Ducati Models With The Siemens Continental ECU (Contitech)

'Tune Only'  Product Option (No Cruise/QS)

Models Covered:

Monster 659,796 and 1100 (2010 to 2014)
Hypermotard 796 and 1100
 
Features:

  • Data Logging
  • Map Editing
  • ECU reflash
 
 
Data Logging

The TuneBoy logging software for the Contitech ECU records the information needed to adjust the fuel mapping on your motorcycle, the software records the RPM, Throttle Position, Engine temperature and up to two wide band Air Fuel ratio inputs (The LC-2 wide band O2 sensor kit is sold seperately).
The logging information is used by the map editing software.
The following screen shot shows the logging software screen.


 
 The logging software will connect to the ECU using WiFi or the USB connection, when you press the Connect button you are asked for a log file name and logging will continue until you close the program.

 
Map Editing:

The TuneEdit_Contitech program allows you to adjust fuel and ignition tables for the Contitech map files.
Maps that you can adjust are the fuel tables for front and rear cylinders, ignition tables for front and rear. You can also adjust the rev limit, speedo and you can change the dash message that appears at startup.
The following screen shot shows the TuneEdit_Contitech program.


 
 The fuel and ignition maps can be viewed as text as shown in the screen shot above or they can be viewed in a graphical view
The screen shot below shows the fuel map in the graphical view.


 
 When you process the log files the TuneEdit program will build a table containing the average air fuel ratio for each of the map points you passed through during the logging session.
The screen shot below shows the TuneEdit_Contitech screen with the data from a logging session.


The values in the A/F tables are used to correct the fuel tables, these corrections are done by the TuneEdit_Contitech program when you select the Correct fuel map option.

 
ECU Reflash:

The Flash_Contitech program handles the task of reprogramming the ECU (Engine Control Unit).
Reflashing the ECU is as simple as starting the program, selecting the map file you want to load and clicking the Flash map into ECU button.
The reflash of the Contitech ECU takes less than two minutes.